FlubRC UTB18 H-Series Scale Bed (coyote chassis)

Scale Bed for UTB18 (coyote chassis)

This scale bed fits the coyote chassis perfectly. The bed rests on the rear shock hoops of the coyote. You can purchase this for the Spydr chassis but cutting slots for the shock towers will be necessary. 

Our UTB18 Body parts will fit the standard and stretched wheel bases for the utb18, while we only make mounts for these 2 chassis for now. You can still mount them via shock tower magnets on most any flat rail chassis!

For gluing parts to the body, you can use a CA glue, or my favorite is Shoe Goe or e6000. The rubbery type glue helps with impacts and is also great for Magnets.

CarbonFiber colors have a print quality increase, including higher temp and impact resistance. It also provides a textured matte finish, the raw prints can be painted without prep if desired. For normal paint preparation, we recommend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved before base coat.

When choosing a color and planning to paint, you have options! You can pick the same color as your paint, so scratches will be less visible!

Bodies do require prep if planning to paint. For prep we reccomend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved.

***All products are made to order. Please check the header on the main page for approximate lead times. Thank you for your support and patience - FlubRC