FlubRC 1:10 E-Series Cab

The E-Series is our original design with some Euro inspiration! You'll find hints and touches of this on the cab, like the raised center and runners on the hood, curves in all of the right places, our new rolled front end with fender cuts that take 4.90 tires perfectly, slantback roof, the new slotted grill with 2 lens options, the iconic quad headlights and a more domestic square style lens, detailed side vents, RHD interior with all new sport seats, handbrake, and modern dash.

The cab also comes with a set of universal MagPodz and 15mm N52 Magnets for mounting. There are mag spots in the lower corners of the cab that would match up with the lower MagPodz mounted to the rear link area. The Upper MagPods mount to the shock towers, and magnet placement on the cab is done after both lowers and uppers are setup.

For gluing parts to the body, you can use a CA glue, or my favorite is Shoe Goe or e6000. The rubbery type glue helps with impacts and is also great for Magnets.

CarbonFiber colors have a print quality increase, including higher temp and impact resistance. It also provides a textured matte finish, the raw prints can be painted without prep if desired. For normal paint preparation, we recommend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved before base coat.

When choosing a color and planning to paint, you have options! You can pick the same color as your paint, so scratches will be less visible!

Bodies do require prep if planning to paint. For prep we reccomend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved.

***All products are made to order. Please check the header on the main page for approximate lead times. Thank you for your support and patience - FlubRC