FlubRC Ascent-18 LoadStar Series (Body Only)

The LoadStar Body Only comes with the Cab, Bed, Interior, Standard Grill, Front Lens, Tail Lens, and MagSliderz with N52 Magnets x8.

The LoadStar Body Kit will work with the A18 Juice Chassis from OrangeCrawlers. The stock chassis does not allow fitment of this body with our MagSliderz.

The LoadStar has been pre fitted with spots to place magnets on the bottom side of bed and rear seat area. They will use 3x2mm magnets and are placed in a 10mm grid. The Accessories also have mag spots and the 10mm grid allows you to place/move the Accessories as needed!

This body kit takes our new Raised MagSliderz. They are the standard width, but raised by 10mm to allow the LoadStar to sit as intended. The LoadStar has shallow wheel well openings and is high clearance with the raised body profile, yet remaining on the lighter side via design!

For all the bells and whistles, the Complete Accessory Pack is available as an "add-on package" in the main LoadStar Collection.

This cab will work with the A-18 Chassis, it has specific mag slots that are lowered to fit this stock chassis.

For gluing parts to the body, you can use a CA glue, or my favorite is Shoe Goe or e6000. The rubbery type glue helps with impacts and is also great for Magnets.

CarbonFiber colors have a print quality increase, including higher temp and impact resistance. It also provides a textured matte finish, the raw prints can be painted without prep if desired. For normal paint preparation, we recommend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved before base coat.

When choosing a color and planning to paint, you have options! You can pick the same color as your paint, so scratches will be less visible!

Bodies do require prep if planning to paint. For prep we reccomend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved.

***All products are made to order. Please check the header on the main page for approximate lead times. Thank you for your support and patience - FlubRC